The Eurorack Power Breakout is a simple and effective way to get a Eurorack power supply connected to your breadboard. The EPB has footprints for a shrouded header, reverse polarity protection diodes, power filtering capacitors, an onboard voltage regulator, and 4 x switched 3.5mm audio jacks. All of your basic power needs are broken out to a single row male header that plugs directly into your breadboard. In addition to power, the 3.5mm audio jacks allow you to easily patch in and out of your breadboard and connect your homemade circuit to your pre existing Eurorack modules. Say goodbye to nasty alligator clips and sloppy home-brew solutions that constantly pop in and out, we’ve got you covered.
**THONK IS NOT LIABLE FOR ANY DAMAGE CAUSED TO YOURSELF OR YOUR EQUIPMENT WHILE USING THIS PRODUCT. PLEASE MAKE SURE YOU KNOW WHAT YOU ARE DOING BEFORE YOU PURCHASE AND USE THIS PRODUCT. IT IS RECOMMENDED THAT A 1K SERIES RESISTOR IS PLACED BETWEEN THE OUTPUT OF YOUR CIRCUIT AND THE 3.5MM JACKS WHEN PLUGGING INTO PRE-EXISTING MODULES – THIS IS FOR CURRENT LIMITING PURPOSES AND MAY POTENTIALLY SAVE YOU FROM BLOWING STUFF UP. WHEN TAKING A SIGNAL FROM YOUR EURORACK INTO THIS CIRCUIT, IT IS RECOMMENDED THAT YOU CONNECT A 100K TERMINATING RESISTOR TO GROUND – THIS IS ALSO FOR CURRENT LIMITING PURPOSES AND MAY POTENTIALLY SAVE YOU FROM BLOWING STUFF UP.